17MM FET DRIVER

Number of light levels: Some people have been able to request custom sets of modes to be programmed into the chip from KD. Choose your own mode levels. Bleeder resistor for lighted tailcaps, varies between ohm optional C1: If you have any more, I would like 2 with Bistro.

Uploader: Mazur
Date Added: 19 April 2004
File Size: 38.28 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 7342
Price: Free* [*Free Regsitration Required]

This driver gives you the best of both worlds: To disable the turbo timer, simply set the time to under 4 seconds. This is the most popular option. Or if you need the space leave them all off and you can then clear any retaining ring you may desire.

ToyKeeper hit this one out of the ballpark! Log in or register to post comments. This may be useful if you are planning on piggybacking this driver onto another driver, or if you have your own preferred spring you’d like to install yourself.

The firmware that can be used with this driver is the Bistro Tripledown variation which can be found here: This system gives you ample warning and attempts to extend runtime before turning the light off. Hi I would like to have 1 Attiny 25 with Bistro. KD uses higher capacity mA regulators instead of the usual mA, allowing for somewhat higher currents.

  COMBOMAX PIKATEL DRIVER

The same can be done in reverse, you can put on the pads. Approximate PWM levels of each mode: The light will blink and your mode group will be memorized. Soldering these numbered pins to ground will enable these features: This is the second most popular option.

You can override any low voltage shut down by holding down the electronic switch button. To switch mode groups: With the light in programming mode, tap the switch the fett number of times as your desired mode group.

FET + Driver – 17mm – MTNDDm

This is the newest update of the guppydrv series by DrJones, now with more modes than ever and thermal protection! The C1 cap is in all cases. Views Read View source View vet. With 1S cells non-zener mod the light will begin to step down output at around 2. In the middle of the second pair the third blinkswitch the light off.

Help with MTN 17mm FET+7135 Driver

The downloads from OSHpark includes the source files for diptrace for anyone that wants to play around with it, along with pictures of the drivers assembled from diptrace to make assembly easier and a schematic for tet one.

  MATROX MGA G200E LINUX DRIVER

ToyKeeper has been at it again! You can check this box if you don’t want the copper braided spring installed or included with the driver.

At around 3V under load, the light will blink three times then step down the power level. Universal guppydrv Clicky Firmware Option.

Help with MTN 17mm FET+ Driver |

For use with more than 1 lithium cell on the input. Soldering these numbered pins to ground will enable these features: Choose your own mode levels. To lock the mode groups: August 31st, Seems like the response was quite big, the drivers are all fef till payment received.

The Low mode is a very dim firefly mode that some people prefer though they make a 8x version with a little higher Low. No Timer 30 Seconds 60 Seconds 90 Seconds Seconds Seconds Spring Option You can check this box if you don’t want the copper braided spring installed or included with the driver.